Glad this is back. Thank you for the improvements and keeping it going
- Welcome to CRG Discussion Forum.
Welcome to the CRG Discussion Forum!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Mild Modifications / Re: '69Z 302 - current header recommendations please?
September 08, 2013, 11:52:24 AM
Hi Charlie
I have Hooker Super Comps-P/N 2131. Fit is okay-had to dimple near the p/s box on cyl. #3 tube, and at the pitman arm. I've seen some posts that state the right side header hit the idler arm. Never had this problem. Also the left collector flange hangs a little lower than the right. Just a side note- I put a set of headers and dual exh. on a 1970 z/28 I had while in college. The power difference was night and day (felt like I put a blower on it). They may be a headache to install, but are well worth the headache. Probably a true 35-40 horsepower improvement.
Good Luck
Harry
I have Hooker Super Comps-P/N 2131. Fit is okay-had to dimple near the p/s box on cyl. #3 tube, and at the pitman arm. I've seen some posts that state the right side header hit the idler arm. Never had this problem. Also the left collector flange hangs a little lower than the right. Just a side note- I put a set of headers and dual exh. on a 1970 z/28 I had while in college. The power difference was night and day (felt like I put a blower on it). They may be a headache to install, but are well worth the headache. Probably a true 35-40 horsepower improvement.
Good Luck
Harry
Pages1