That will be my next step with a magnet on a flexible tube. My last resort will be to drop the pan if the magnet doesn't work I guess.
- Welcome to CRG Discussion Forum.
Welcome to the CRG Discussion Forum!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Decoding/Numbers / dip stick broke off inside motor
November 04, 2009, 03:18:55 PM
The lower portion of the dip stick broke off inside the engine @ the full mark. Could this get inside the motor & cause damage or should I assume that it is laying in the bottom of the pan and not worry about it? Looking foe suggestions.
#3
Originality / machined pad stamp vs re-stamp, 69 Z28
October 12, 2009, 07:43:42 PM
How can I tell if the numbers on the milled motor pad is an original or a re-stamp?
#4
Decoding/Numbers / Re: can't find 69 engine block vehicle code
September 22, 2009, 12:51:34 PM
Hi Paul
The build date is October 25, 1969 at the Norwood plant. I'll have to send pic in a day or so.
The build date is October 25, 1969 at the Norwood plant. I'll have to send pic in a day or so.
#5
Decoding/Numbers / can't find 69 engine block vehicle code
September 21, 2009, 01:26:19 PM
I can't find the partial engine block vehicle code on my 69 Z. Production code only on the deck stamp, can't find near the oil filter. Help!
Pages1