Messages

Sorry should have Posted this is A legit DZ 302 V0911DZ

I just pick up this long block

https://www.youtube.com/watch?v=aY1bLFKbRuA

Yes, make sure that you check that ALL MOUNTING PINS are in tact, if not have the WELD in type installed. I would not recommend the screw in type replacement as they will fail. The weld in type are easy to install check with your local body shop they should have a Stud/Dent puller   Welding gun that can weld them in no time. the studs  usually come with this tool  and are forgotten about as they are not used as much on Modern cars anymore. There should a BAG of them in the case that the tool comes in Very SMALL  Pin studs.

Front windshield clips are RED Oxide, rear are either a"Gun Metal" Color or Black any of the parts houses have them .Yours were probably changed at some point or the originals rusted away and were change with what ever was available 

Thanks Ron, Happy to help out. Great car, nicely done, a pleasure to work on.

Thanks Jeff   ... sent you a PM

Installed with (Modern) Urethane adhesive Correct type Foam Dam just like the factory did it.I haven't posted on here in a long time ,but  I told Ron  I would post them for him. Did this over the weekend,not a bad ride to West Point Thanks RonM