Typically it's 30-90 days...So you are right at the "cut off"..But i'd say its decent chance of being origianal.....Does it have the deep grove pulley with GM part #?
- Welcome to CRG Discussion Forum.
Welcome to the CRG Discussion Forum!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Decoding/Numbers / Part of suffix code/assembly date cut off under cylinder head....Possible?
July 16, 2008, 11:40:18 PM
I'm trying to verify authenticity of #'s for a friend on a 69 L78 Camaro....The suffix code/assembly date is partially under the cylinder head...IS the possible?
Was the deck stamped prior to cylinder head installation?
I thought it was done AFTER the engine was completely assembled which would make this block a restamp..Just wondering...Seller swears its a legit stamp..
Was the deck stamped prior to cylinder head installation?
I thought it was done AFTER the engine was completely assembled which would make this block a restamp..Just wondering...Seller swears its a legit stamp..
#3
General Discussion / Tailpan blackout on 69' tuxedo black SS396?
August 01, 2007, 01:31:05 AM
Did 1969 396 tuxedo black cars recieve the semi-flat paint on the rear tailpan? I got one at work i'm finishing up, and figure i'd check before pulling the trigger..
#4
Decoding/Numbers / Re: 69 Z database
October 29, 2006, 09:23:12 PM
Did LA cars also feature this bulkhead marking? I took the seat out of a semi-original VN Z recently, and nothing...
#5
Decoding/Numbers / Re: your thoughts on date code 302
August 10, 2006, 11:56:40 PM
Probably too early.....The most i've ever seen is about 3 weeks from engine assembly date to car build date
Pages1