Messages

Again, thank you for the input guys. Did not think GM would offer a part like that.

Thoughts on this set up Warren?

William, Warren, I bought my 69 Z/28 in April of 2000. The original console and gauges had been added before I bought the car. I noticed the oil pressure sending unit fitting and line with the idiot light sending unit attached to each other. Never saw that before but no big deal, it works. 19 years later I see on Ebay the "EXACT" same setup block, nipple, line fittings everything as my car has. Never saw that anywhere but on my car. Still has to be a homemade set up but.................weird.

EBAY # 333238335102

Thanks,  Sam

Neither have eye but the guy on Ebay believe's it exists. Thanks for the response.

Sam

Does a 69 Z/28 with a console and gauges also get an idiot light  sending unit along with the plastic line? There is a unit on Ebay showing a copper/brass nipple with a brass block with the oil line fitting and oil sending unit as an assembly. The person said he removed it from a 69 Z/28 with console gauges where the idiot lights in dash and console gauges both worked.

Could this be something GM offered as over the counter parts to people who wanted to add a console to their camaro?

thanks for the help.

Sam

I am Jim. That is why I want to buy the correct one. I found a couple NOS ones in the box but are slightly different. Just wanting to make sure I buy the correct "assembly line" version. Thanks for the response and the photo.

Do all the assembly line "manual" rag joints (#7806391) come with the ground strap? I have the original one on my 69 Z that needs to be replaced. I see some NOS ones with and some without the ground strap for sale. My Z/28 is an 11D of 68 car if that matters.

Thanks,  Sam

I have the original on my 69 Z/28 that I painted and also have the original  one on my 69 "survivor" SS nova that has the rubber based paint on it. I bet they were dipped some how to help with the battery acid.

Thanks Joe.  Sam

Other than the VE3 load rest is any other part of the jack painted blue?  Thanks!

I have an 11D Z/28 and my bulkhead reads DG3. I have a dark green interior and an X33 car.

a steel 283 crank will also work.

I believe the 69 Z/28 frame mounts should have 507 and 508 as a part number on them.

I believe natural finish.

not sure it is worth all your time, money and effort. Its pretty bad in my opinion but?