News:

Classified ads are not allowed on the forum.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - m22mike

#1
Quote from: BRG Z28 on March 17, 2020, 06:50:16 PM
Can you please clarify if "l" or "H" was used for 1968 carrier date stamping? I heard that "I" was skipped in the alphabet.

Look through this thread at yenko.net. Post 12 has a shot of a 68 unit stamped "I"
https://www.yenko.net/forum/showthread.php?t=159670
#2
Great info and a awesome article  Byron. Glad you could use a photo of mine.

Mike
#3
Restoration / Re: Painting details...
February 29, 2020, 01:29:16 PM
Nice dash texture.

Mike
#4
Originality / Re: 69 horn bolts
February 29, 2020, 01:23:50 PM
Yes Chick. I have seen a few very early built 69's with bright plated bolts. There was most likely a transition period until old stock was used up.
Not a Camaro, but on Grady's Nov 68 built 69 Nova, it had a bright plated horn bolt. I believe a hardware Change like this and others was across the whole GM line ? Not just Camaro JMO.

Mike
#5
Originality / Re: 69 horn bolts
February 26, 2020, 07:39:31 AM
Quote from: m22mike on February 25, 2020, 09:09:39 PM
They were removed by a revision to the A.I.M dated 10/68.

I should have added that the zinc plated bolts were changed to the same phos bolts that holds the lower hood latch. The numbers are there, and somewhat hard to read in the revision box, depending on your copy of the AIM. Later I will look up a page # for you.
Mike
#6
Originality / Re: 69 horn bolts
February 25, 2020, 09:09:39 PM
They were removed by a revision to the A.I.M dated 10/68.
#7
General Discussion / Re: Burgundy Z with Red stripes
January 09, 2020, 06:36:55 PM
IMO, great Color combo, worked OK for the SS stripe.
Mike
#8
General Discussion / QG 4:56 Axle
December 19, 2019, 08:04:45 AM
Any thoughts on the value of a bare 67 Camaro metallic brake QG 4:56 axle, no pitting VG condition.

Thanks Mike
#9
General Discussion / Re: Dash carrier removal
October 24, 2019, 03:42:39 PM
Take the seat out too, well worth doing.
Mike
#10
I talked with the owner Sunday, close to paint and it will be at MCACN.
Mike
#11
General Discussion / Re: Passenger door mirror
June 28, 2019, 05:34:47 PM
Quote from: joesauer on June 28, 2019, 02:24:45 PM
Too many close calls backing out of my garage.  It's time to install a passenger-side door rear view mirror on my '68.   Checked out various posts, but still not sure exactly how far back to mount it.   Would like to locate it similar to drivers side mirror, but not sure this would give me good side/rear visibility when sitting in the drivers seat.   Any suggestions?

You might also look into buying a Scott Drake mirror with a modern convex mirror. I have one on my 69 Chevelle and it is great, especially when driving. Hi quality mirror, check Summit Racing.
Mike
#13
General Discussion / Re: 1969 Z/28 Cowl Tag Removed
April 23, 2019, 07:23:06 PM
Nice cowl seal :>o
#14
General Discussion / Re: Opinions...
March 09, 2019, 08:18:46 PM
My bad ? After another look I have droughts that it it a repop.
Mike
#15
General Discussion / Re: Opinions...
March 06, 2019, 08:16:53 PM
Reproduction tag.