News:

Classified ads are not allowed on the forum.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - roadster

#1
Garage Talk / Re: Shelby Camaro?
November 25, 2021, 04:50:41 PM
Shelby wanted to use Chevy engine instead of Ford but GM said no . Check out Scaglietti Corvette for some interesting history . Did not see the movie so don't know if this was covered . Italian body on 59 Corvette frame and running gear .
#2
Hope you were able to obtain the incredibly rare part , anxious to see what it is . Rare parts are the icing on the cake ! You are perfect caretaker for this car from what I've seen .
#3
I'm not Dave but do know him , I actually live in the fair city (Fairborn ) Dave lives in same county different city. And picture of vr would be appreciated . Thanks .
#4
And you can tell the boss that I think she should be honored to have you work on this car at you alls house !
#5
Manual steering boxes were same for several years ( Camaro , Chevelle , Nova and full size cars same just different pitman arms ) , longer pitman arm and different steering knuckles made for quicker steering ratio for Z cars and other cars ordered with f41 suspension . Have read if you ordered optional f41 on top of Z28 (very rare )steering boxes were couple turns less lock to lock ( different internals same outer casting and casting # ) and very difficult to turn if not rolling ( no fun at all to parallel park , not even for Popeye ) . Yours looks to be cast on 105 th day . The assembly date was  typically 5 + - days after . Assembly date should be stamped on raised pad ( just need to wipe off dirt to see stamp ) near cover .  Julian date followed by 9 for year . Hope to see this one at WTWW in Fairborn 2022 !
#6
Great car , glad to see it preserved . Can you check date on voltage regulator and post ? I had heard or read somewhere that red mark on trunk seal means it passed leak test .
#7
General Discussion / Re: Rumble @55-65 mph
August 28, 2021, 01:29:40 PM
Pinion angle vibrations tend to be most noticeable around 60 mph as I recall. Might try to change trans angle at crossmember with washers , see if it gets better or worse .
#8
General Discussion / Re: Y 77 Battery
May 12, 2021, 03:00:17 PM
Check out amazing survivor thread under original cars. First page shows original battery and y77 replacement (pictures and describes difference) . Both battery's were saved from when car was new .
#9
Maintenance / Re: Clutch Issues
May 05, 2021, 09:09:33 AM
Fork tabs in relation  to throw out bearing seem to be an issue for some . Some people seem to install fork onto bearing so the tabs rather than the fork apply pressure to bearing . Something to check if you are not sure .
#10
General Discussion / Re: New 69 Z28
September 15, 2020, 02:56:43 PM
Very nice car . Congrats ! Could you specify the dates on the yh rims ? Thanks .