« previous next »
Pages: [1]

Author Topic: 69 clock bulb  (Read 5629 times)

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
69 clock bulb
« on: March 21, 2011, 12:18:29 AM »
I just got my clock back from being repaired. Went to put it in and the bulb socket wont fit. I have the blade type bulb in it that is oblong and it seems to bottom out. What bulb does it take? Rick's shows a console bulb but mine has a connector with the "push in" not twist bulb. 

Thanks CRG
Mike
Logged

Gramps69Z

  • Hero Member
  • *****
  • Posts: 653
  • 69 X33 D80
    • View Profile
Re: 69 clock bulb
« Reply #1 on: March 21, 2011, 01:01:58 AM »
Logged
Captain John Wykoff
Destin Fire:   October 31, 2015 at 0700--Officially Retired

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #2 on: March 21, 2011, 01:29:46 AM »
That looks like what I have now. The socket just wont fit in the clock though. It's like it's too long



Thanks

Mike


Logged

IZRSSS

  • Guest
Re: 69 clock bulb
« Reply #3 on: March 21, 2011, 01:45:00 AM »
The AIM indicates part# 9425542 {bulb}...you must also have the correct Wire Assembly/Socket; part# 6297523 {note; the adjustment knob is a part of the wire ASM}
Logged

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #4 on: March 21, 2011, 02:03:56 AM »
I'll check it again tomorrow.

Thanks
Logged

IZRSSS

  • Guest
Re: 69 clock bulb
« Reply #5 on: March 21, 2011, 02:16:35 AM »
Here's the AIM sheet...
Logged

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #6 on: March 22, 2011, 12:52:22 AM »
Looks like the clock base itself has been hot and is slight concave in it. I"ll have to figure out something to make the socket stay in the housing
Logged
Pages: [1]
« previous next »
 

anything