Author Topic: Endura bumper jacking instructions - different then standard bumpers? (Read 9672 times)

smith69z · « **on:** August 19, 2009, 07:16:56 PM »

Did GM have a different sticker on the trunk lid for endura bumper equipped cars? And if so does anyone reproduce them?

JohnZ · « **Reply #1 on:** August 20, 2009, 03:18:49 PM »

The Assembly Manual doesn't show a unique-to-VE3 jack instruction sticker either in the VE3 section or in the UPC 10 jack section.

smith69z · « **Reply #2 on:** August 23, 2009, 10:54:47 AM »

Thank you for your time to answer John. I have been holding off on this sticker until I was sure.

firstgenaddict · « **Reply #3 on:** September 26, 2009, 07:06:12 AM »

Here is an original paint VE3 vintage legend certified instructions

Oaklyss · « **Reply #4 on:** September 26, 2009, 07:55:53 PM »

Heres my original paint car, original VE3, jack sticker:

Oaklyss · « **Reply #5 on:** September 26, 2009, 08:04:51 PM »

Wait, heres a close up.

crobjones2 · « **Reply #6 on:** September 27, 2009, 12:22:53 AM »

does anybody have any pics of the ""straps" used to hold the wrench to the jack?

JohnZ · « **Reply #7 on:** September 27, 2009, 02:31:37 PM »

Wait, heres a close up.

That's the standard jack instruction sticker - same as my original non-VE3 '69 Z/28.

JohnZ · « **Reply #8 on:** September 27, 2009, 02:32:50 PM »

does anybody have any pics of the ""straps" used to hold the wrench to the jack?

Don't have a photo handy, but they're wide, heavy black rubber bands.

Oaklyss · « **Reply #9 on:** September 27, 2009, 03:22:01 PM »

My point is, they are the same. There is no speciial VE3 sticker.

smith69z · « **Reply #10 on:** September 28, 2009, 09:26:33 PM »

Thanks guys!!

News: