Template for AC vacuum Canister on Drivers side firewall

[hdptsr]

Does anyone have a template for the mounting of the AC Vacuum reservoir canister on the drivers side cowl of the firewall?

[x66 714]

I have a picture that might be helpful but the car is back together.....Joe

[Petes L48]

I don't think they were exact on where it was mounted, unless there were dimples in the cowl to mark where to drill.  Looks like it generally straddles the "X" stamp.  The 67 AIM doesn't show any specific measurements for drilling holes.  This is from an 11B 67 LOS car. 

 



 

[FLA-67RS]

Attached are two pictures from a 12A LOS 67. Hope it helps.

[hdptsr]

Thanks, that should help!

[hdptsr]

what hose goes on the bigger port of the AC vacuum canister?  Is it the vacuum Source or the AC controls?

[x66 714]

The large port goes to manifold vacuum....Joe

[hdptsr]

Thanks Joe, I was looking at the assembly manual and it calls for a 9428471 screw to mount the tank, but cannot find it anywhere on the internet.  Do you have a pic of the proper screw?

[x66 714]

Thanks Joe, I was looking at the assembly manual and it calls for a 9428471 screw to mount the tank, but cannot find it anywhere on the internet.  Do you have a pic of the proper screw?

I doesn't look like I took a picture of it. Let me look tomorrow & I'll see if I can describe it....unless somebody has a known picture....Joe

[FLA-67RS]

Here is a picture of the vacuum cannister attachment screw.

[Petes L48]

I checked my old AMK catalog and they didn't have that p/n listed in the back,  just 469 then 472