« previous next »
Pages: [1]

Author Topic: Cowl Hood Accel Lever Finish  (Read 2493 times)

Z10Mike

  • Member
  • ***
  • Posts: 128
    • View Profile
Cowl Hood Accel Lever Finish
« on: July 19, 2023, 01:40:19 AM »
Looking for feedback on correct finish for the cowl hood accelerator lever and bolt.  After the grunge was removed it looked like it may have had some black paint on the lower part near the clamp bolt. 
Logged

169INDY

  • Hero Member
  • *****
  • Posts: 1892
    • View Profile
Re: Cowl Hood Accel Lever Finish
« Reply #1 on: July 19, 2023, 02:56:51 AM »
I used: Palmetto Enterprises Products. https://www.palmettoenterprisesparkerizing.com/

Manganese Phosphate for the Hardware (Black)
Zinc Phosphate for the Arm (Gray)
Logged
Jim
68 SS/RS L35 Th-400 LOS
69 Pace Car L48 Th-350 LOS
68 Z28 M21 LOS

Z10Mike

  • Member
  • ***
  • Posts: 128
    • View Profile
Re: Cowl Hood Accel Lever Finish
« Reply #2 on: July 19, 2023, 08:10:51 PM »
The arm had a lot of oil/dirt encrusting it when I pulled it off.  When that was removed it had a dull dark gray finish on it.  So there may be some of the original phosphate finish still there. 
Thanks again for the info.
Logged

169INDY

  • Hero Member
  • *****
  • Posts: 1892
    • View Profile
Re: Cowl Hood Accel Lever Finish
« Reply #3 on: July 19, 2023, 09:13:15 PM »
Glass bead with LOW pressure to preserve finish, Vapor blast would be best but difficult to source.
Logged
Jim
68 SS/RS L35 Th-400 LOS
69 Pace Car L48 Th-350 LOS
68 Z28 M21 LOS
Pages: [1]
« previous next »