Author Topic: HELP: Neutral Safety Switch wiring detail  (Read 2492 times)

vabeach56wagon

  • Member
  • ***
  • Posts: 69
    • View Profile
HELP: Neutral Safety Switch wiring detail
« on: August 16, 2022, 04:22:23 PM »
Is the feed off the neutral safety switch continuous, once past the two-prong connection, all the way to the solenoid? When the solenoid would no longer engage, I thought the relatively new neutral safety switch had gone bad. I bypassed the neutral switch by bridging the ignition switch feed to the existing solenoid feed...alas, still no activation at the solenoid.

I then installed a jumper wire from the solenoid to the outlet side of the neutral switch and, voila, the solenoid powered up off the ignition switch and I was able to start the car.

In my wiring diagram I see no junction on the purple feed to the solenoid other than the one directly above the pedal assembly. Is there one further downstream I should look for. I'm trying to avoid tearing into the harness.

paul

David K

  • Hero Member
  • *****
  • Posts: 1198
  • Dr. Longblock
    • View Profile
Re: HELP: Neutral Safety Switch wiring detail
« Reply #1 on: August 17, 2022, 01:09:50 AM »
Year? Trans?

vabeach56wagon

  • Member
  • ***
  • Posts: 69
    • View Profile
Re: HELP: Neutral Safety Switch wiring detail
« Reply #2 on: August 17, 2022, 11:39:43 PM »
'69 Muncie - new harnesses throughout -