Tips on installing a new pinion snubber

[Tinkerr]

I've tried WD-40 type lubricants, synthetic grease, dish soap, dish soap with a rope pulling up through the mount. Similar to installing windshields with a rubber. No success. Looking for Idea's. Thanks

[cook_dw]

Silicone spray and a large screw driver.  Never had an issue.  Sit one side of the mount in and rotate the other side in with the persuasion of a large screw driver.

[Tinkerr]

 I've been trying, without much success, not to scratch anything. so I didn't try the screwdriver. I'll give that a try today. Thanks

[R68GTO]

I ended up using a floor jack to continually apply pressure while I poked with a large flat blade screwdriver.  They are tough little buggers.

[Tinkerr]

I'm assuming you didn't have to contend with the drive shaft to use the floor jack method? The screwdriver method didn't work, just frustrated me, I had to walk away. I just picked up the computer to look for another style snubber.

[R68GTO]

Correct, drive shaft was out.  Clarification on the jack use, my memory had a gap in my original post.  I put a jack in place a foot or so away from the snubber and used it as the fulcrum for a pc. of 2x4 which applied the pressure on the snubber.  one hand on the 2x4, one hand with flat blade

[ALLZS]

I have installed a lot of them so I made a tool a piece of angle iron  welded to a flat piece  I use my transmission jack boom they pop right in

[Tinkerr]

Task Completed!!! I used my Bridge Jack and put together a contraption that worked amazing. I took 2 pictures of the contraption. Thanks for the replies and help, always appreciated.

[R68GTO]

Well done!

[firstgenaddict]

Nice job... I like the single crimp brake hose too