« previous next »
Pages: [1]

Author Topic: Heater hose connector  (Read 3357 times)

upscope757

  • Member
  • ***
  • Posts: 152
  • Almost there...
    • View Profile
Heater hose connector
« on: September 02, 2019, 01:16:09 PM »
All, looking for how to connect the heater hoses to the inner fender. I have the small metal clip but don't see how that connects to the square hole in the fender well. Is there another clip I am missing? Tks!
Logged
Matt: 1967 RS/SS - L48/Powerglide - Sierra Fawn/Beige Vinyl Top, Charleston, SC

JESSE TACKETT

  • Member
  • ***
  • Posts: 55
    • View Profile
Re: Heater hose connector
« Reply #1 on: September 02, 2019, 01:24:47 PM »
tabs on the back of the clip are spread after fitting through the square hole....
Logged

upscope757

  • Member
  • ***
  • Posts: 152
  • Almost there...
    • View Profile
Re: Heater hose connector
« Reply #2 on: September 09, 2019, 04:13:13 PM »
Tks!
Logged
Matt: 1967 RS/SS - L48/Powerglide - Sierra Fawn/Beige Vinyl Top, Charleston, SC

Randy Mitton

  • Member
  • ***
  • Posts: 37
    • View Profile
Re: Heater hose connector
« Reply #3 on: September 09, 2019, 08:53:47 PM »
Run engine for a bit until hoses heat up it makes it easier to clip the bracket
Logged

Kelley W King

  • Hero Member
  • *****
  • Posts: 1435
    • View Profile
Re: Heater hose connector
« Reply #4 on: September 10, 2019, 11:19:24 AM »
Thanks for that tip Randy. Seems so simple but I never thought to warm up the hoses to clip that bracket. One of my cars needs that done.
Logged
69 Z28 RS Scuncio Hi Performance
69 SS L78
67 SS Chevelle
64 Corvette
66 GTO Tiger Gold
77 Trans Am Special Edition
Pages: [1]
« previous next »
 

anything