« previous next »
Pages: [1]

Author Topic: Defogger switch  (Read 4974 times)

camaroman1969

  • Member
  • ***
  • Posts: 141
    • View Profile
Defogger switch
« on: December 05, 2017, 02:03:24 AM »
I would like to install a "defogger blower" on my 1969 Camaro SS/RS.  Question: Does one have to cut dash, or is this already pre-cut behind the wood grain covering??  All comments will be appreciated.  Thanks guys!   Don
Logged

william

  • CRG Member
  • *****
  • Posts: 3189
    • View Profile
Re: Defogger switch
« Reply #1 on: December 05, 2017, 02:43:33 AM »
Not pre-cut. The woodgrain trim was pre-punched for the switch if the car was ordered with a defogger. Dimensions for the dash are shown in Section C50 page A1 of the Assembly Instruction Manual.

Logged
Learning more and more about less and less...

camaroman1969

  • Member
  • ***
  • Posts: 141
    • View Profile
Re: Defogger switch
« Reply #2 on: December 05, 2017, 04:25:46 AM »
Thanks Bill.  Doesn't look like its gonna be a easy task to install this defogger.
Logged

camaronut

  • Hero Member
  • *****
  • Posts: 717
    • View Profile
Re: Defogger switch
« Reply #3 on: December 06, 2017, 12:11:00 AM »
Nothing a dremel tool can't handle.  Been there, done that.
Logged

Boston14

  • Member
  • ***
  • Posts: 252
    • View Profile
Re: Defogger switch
« Reply #4 on: December 10, 2017, 12:21:39 AM »
I believe the woodgrain trim for a convertible with power top is the same.
Logged
boston14

1969 SS/RS 350 Convertible
Dover White with Black Top and D90 stripe, Red Standard Interior

Charley

  • Hero Member
  • *****
  • Posts: 713
    • View Profile
Re: Defogger switch
« Reply #5 on: December 10, 2017, 02:28:21 AM »
There was also double bezel for convert top and rear window defog
Logged

camaroman1969

  • Member
  • ***
  • Posts: 141
    • View Profile
Re: Defogger switch
« Reply #6 on: December 20, 2017, 11:58:30 PM »
Thanks guys for all your input.  This will help. 
Logged
Pages: [1]
« previous next »
 

anything