BV Water Pump Pulley

[z28z11]

Sorry for the late entry, but I've been out of town for a couple of weeks and could not add my 2 cents -

The 2456DV pictured is off my X77, definite original, and the inner support is not swaged in place, but is spot welded as shown. This is the original finish on the pulley as well - appears to be dark grey phospate on the front side, or maybe dulled semi-flat black.

The 824BV shown is a repop. The two pulleys are different in diameter by quite a bit - no wonder the belts needed to be swapped according to My68SS -

Regards,
Steve

[z28z11]

I owned a '53 Henry J for over 25 yrs!!

Gary - are you sure it wasn't an Allstate ? I've heard how cost conscious you are -

Regards,
Steve

[69Z28-RS]

I owned a '53 Henry J for over 25 yrs!!

Gary - are you sure it wasn't an Allstate ? I've heard how cost conscious you are -

Regards,
Steve

Nope, it was a Henry J..     but I've seen a few Allstates in my day..  when searching for Henrys..

[L78 steve]

Sorry for the late entry, but I've been out of town for a couple of weeks and could not add my 2 cents -

The 2456DV pictured is off my X77, definite original, and the inner support is not swaged in place, but is spot welded as shown. This is the original finish on the pulley as well - appears to be dark grey phospate on the front side, or maybe dulled semi-flat black.

The 824BV shown is a repop. The two pulleys are different in diameter by quite a bit - no wonder the belts needed to be swapped according to My68SS -

Regards,
Steve

So this is non original?

[ko-lek-tor]

Sorry for the late entry, but I've been out of town for a couple of weeks and could not add my 2 cents -

The 2456DV pictured is off my X77, definite original, and the inner support is not swaged in place, but is spot welded as shown. This is the original finish on the pulley as well - appears to be dark grey phospate on the front side, or maybe dulled semi-flat black.

The 824BV shown is a repop. The two pulleys are different in diameter by quite a bit - no wonder the belts needed to be swapped according to My68SS -

Regards,
Steve

So this is non original?

What are you trying to say? and what does any of that have to do with a 2456? or the pic of a repop 824?

[L78 steve]

I'm trying to figure out which is correct the spot welded or swaged design pulley.