My New '68 Camaro Z/28 Butternut Yellow

[janobyte]

very good stuff,sounds trivial ,but could you shoot a close up of a lug nut ? Need to check the outside , thanks. Seem to think I changed a couple years ago for some reason.

[dannystarr]

Jano,
 Not a problem, going to girlfriends garage tonight to pull the carb for rebuild. I will do it then.....Danny

[janobyte]

Here's one of my rims Danny...I'll shoot you number's off my Z for comparison if you want, let me know . When you get to your seat belts and carpet let me know--steve.

[dannystarr]

Here is alt brackets with "GT" stamping. Oddly the black bracket is stamped beautiful and deep. The red bracket is only stamped with a "T".    No G, at least any "G" that I could see. Was this common?? ... Danny

[dannystarr]

Red Bracket ... Danny

[dannystarr]

Red Bracket with only a "T"... Danny

[dannystarr]

Was able to get a picture of the lower pulley while changing water pump.   3858533  BJ    GM  or is that a 5 ??  What does the BJ stand for ??... Danny
                                                                                                                                   S

[dannystarr]

Front of engine while cleaning and changing water pump... Yes, I see the wrong clamps on bypass and heater hose... Danny

[dannystarr]

center of front engine... Danny

[dannystarr]

Body Panel Numbers I have found.

            Misc.. Stamped Body Panel Numbers

                     Hood Left Rear Edge – 20
                                            Fenders – 20
              Header Panel Top of Cowl – 20
                        Left Quarter Panel – H21   
                   Underside of Deck Lid – T20

[68camaroz28]

Hi Danny and great find! What a girl friend! Just got back from vacation this morning and thanks for the email and kudos on my build thread, and yes, we now have Camaro relatives, huh! Great pictures and documentation so thank you! On the GT stamp, know I have not observed enough to have any idea if having the T only was common as many things could have been possible but we now know of one, yours. Hard to find examples like this with so much of the original content still there. I would tend to believe the PCV has been changed due to being a later design but maybe an expert will chime in. Again, great 68Z and congratulations.

[dannystarr]

Jano, Here is a couple shots of the lugnut... Danny

[janobyte]

thanks , thread one has to check a few times a day....or your missing out

[69Z28-RS]

Was able to get a picture of the lower pulley while changing water pump.   3858533  BJ     GM  or is that a 5 ??  What does the BJ stand for ??... Danny
                                                                                                                                    S

I'm not sure what the BJ stands for, but most if not all pulley PN's have a 2 letter code after the PN...
Your crank pulley is correct for your Z28...     .. complete pulley list From the CRG information....
http://www.camaros.org/pdf/pulleys-68-2007-02-01.pdf

Z/28 (w/smog)                     Base                  N-40
Crank pulley                     3858533              3858533
Crank pulley extension            N/A                3916385
Water Pump pulley             3770245             3770245
Alternator pulley                 1970831             1970831
Smog Pump pulley              3925522             3925522
Power Steering pulley              N/A                3873847

[janobyte]

mine Dan