« previous next »
Pages: [1] 2  All

Author Topic: Purpose of this bracket??  (Read 13103 times)

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5781
  • owner since 4-Apr-1976
    • View Profile
Purpose of this bracket??
« on: June 25, 2014, 08:27:47 PM »
Can anyone identify the purpose of the bracket shown in the photo below?   It's welded to the body, slightly behind and above the rear end on the driver's side...   If I removed anything from this bracket, I can't recall what it was..  :)
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan

Stingr69

  • Hero Member
  • *****
  • Posts: 910
    • View Profile
Re: Purpose of this bracket??
« Reply #1 on: June 25, 2014, 08:35:28 PM »
Muffler hangar bracket is my guess.
Logged

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: Purpose of this bracket??
« Reply #2 on: June 25, 2014, 08:52:13 PM »
Check out UPC 8, sheet A4 in the 69 AIM.

Ed
Logged

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5781
  • owner since 4-Apr-1976
    • View Profile
Re: Purpose of this bracket??
« Reply #3 on: June 25, 2014, 10:55:31 PM »
Was that hangar bracket used on dual exhaust cars?  Or only on single exhaust V8 and L6 cars?? I don't think anything has ever been attached to that bracket since I've owned the car (1976).. I took off the original exhaust and replaced it with GM parts at that time....
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: Purpose of this bracket??
« Reply #4 on: June 25, 2014, 11:13:27 PM »
Looks like only single exhaust cars. I don't see any reference to it in the N10 or the NC8 option pages.

Ed
Logged

ko-lek-tor

  • Hero Member
  • *****
  • Posts: 1858
  • someday I'll get one finished
    • View Profile
Re: Purpose of this bracket??
« Reply #5 on: June 25, 2014, 11:45:36 PM »
Quote from: Ed Bertrand on June 25, 2014, 11:13:27 PM
Looks like only single exhaust cars. I don't see any reference to it in the N10 or the NC8 option pages.

Ed

To clarify Gary, single exhaust usage only, but ALL cars got it regardless.
Logged
Bentley to friends :1969 SS/RS 396 owned 79
1969 SS 350 (sold)
1969 D.H.COPO replica 4spd. owned since 85
1967 302 4 spd 5.13

69Z28

  • Hero Member
  • *****
  • Posts: 928
  • 69 X33D80 Z28
    • View Profile
Re: Purpose of this bracket??
« Reply #6 on: June 26, 2014, 01:56:00 AM »
Probably there to hold up that end of the muffler? I thought I just saw recently the tail pipes were welded to the muffler OEM? Was there a bracket attached to the frame rail on the passenger side for single exhaust?

 Hey Gary, look on the driver side, I assuming yours is passenger side? There should be a bracket there too. Here is a pic of the one on my car driver side I noticed when I dropped my gas take a few years ago. If I'm looking at the orientation of your pic that should be drivers side correct?
Logged
GaryC

'UNRESTORED' 1969 Cortez Silver Z28 X33 D80

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5781
  • owner since 4-Apr-1976
    • View Profile
Re: Purpose of this bracket??
« Reply #7 on: June 26, 2014, 02:37:04 AM »
Quote from: ko-lek-tor on June 25, 2014, 11:45:36 PM
Quote from: Ed Bertrand on June 25, 2014, 11:13:27 PM
Looks like only single exhaust cars. I don't see any reference to it in the N10 or the NC8 option pages.
Ed
To clarify Gary, single exhaust usage only, but ALL cars got it regardless.

Thanks guys..  I'd been wondering what that was for, as I didn't recall it ever being used since I'd had the car, and it appears to have Never been used...  :)
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5781
  • owner since 4-Apr-1976
    • View Profile
Re: Purpose of this bracket??
« Reply #8 on: June 26, 2014, 02:39:16 AM »
n
Quote from: 69Z28 on June 26, 2014, 01:56:00 AM
Probably there to hold up that end of the muffler? I thought I just saw recently the tail pipes were welded to the muffler OEM? Was there a bracket attached to the frame rail on the passenger side for single exhaust?

 Hey Gary, look on the driver side, I assuming yours is passenger side? There should be a bracket there too. Here is a pic of the one on my car driver side I noticed when I dropped my gas take a few years ago. If I'm looking at the orientation of your pic that should be drivers side correct?

No Gary, that is on the drivers side; nothing on the passenger side, and apparently that bracket is put on the bottom of the body for all cars, but only used for single exhaust cars.   Dual exhaust cars use the brackets we've discussed many times before.. :)
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan

Hans L

  • Member
  • ***
  • Posts: 381
    • View Profile
Re: Purpose of this bracket??
« Reply #9 on: June 26, 2014, 02:52:08 PM »
Quote
To clarify Gary, single exhaust usage only, but ALL cars got it regardless.

Hmmm...just checked my '69 Van Nuys Built Z and no bracket.  Original floor pans.  No sign it was removed.   Sure all cars go it?   I don't have a good picture of that area, but can post later.

Logged
https://www.instagram.com/69camarorsz28/
'69 Camaro RS Z/28 Van Nuys Built
'69 Chevelle SS 396 4 Speed
'70 Camaro SS L78

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5781
  • owner since 4-Apr-1976
    • View Profile
Re: Purpose of this bracket??
« Reply #10 on: June 26, 2014, 04:50:36 PM »
Quote from: Hans L on June 26, 2014, 02:52:08 PM
Quote
To clarify Gary, single exhaust usage only, but ALL cars got it regardless.

Hmmm...just checked my '69 Van Nuys Built Z and no bracket.  Original floor pans.  No sign it was removed.   Sure all cars go it?   I don't have a good picture of that area, but can post later.



Your car has been restored, hasn't it Hans?  Perhaps it was removed as 'unnecessary' during that process?   OR perhaps they weren't consistent with putting it on?  Bryan302 told me this morning he didn't find it on his '69 either...

Maybe we need another 'research' activity to determine what percentage (or time of year?) taht dual exhaust cars got that bracket mounted to the body....?
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan

Hans L

  • Member
  • ***
  • Posts: 381
    • View Profile
Re: Purpose of this bracket??
« Reply #11 on: June 26, 2014, 05:56:36 PM »
I have pre-restoration pictures and did the restoration myself.  I can't find any signs of the bracket.  Pretty sure it was never there.

Here's some pics - I don't have a the exact pic with the location, but you can tell from these, it's not there.

Pre-Restoration Clean-up of Underside of Trunk Pan:



Side-view, pre-restoration:






Primered:


Logged
https://www.instagram.com/69camarorsz28/
'69 Camaro RS Z/28 Van Nuys Built
'69 Chevelle SS 396 4 Speed
'70 Camaro SS L78

BULLITT65

  • Hero Member
  • *****
  • Posts: 4480
    • View Profile
Re: Purpose of this bracket??
« Reply #12 on: June 26, 2014, 09:11:19 PM »
Well there is a nice pic of the reinforcement plate for the exhaust...  :)
Logged
1969 garnet red Z/28 46k mile unrestored X77
-Looking for 3192477 (front) spiral shocks 3192851 (rear)
-Looking for an original LOF soft ray windshield
-Looking for original Delco side post negative battery cable part # 6297651AV

Bryan302

  • Member
  • ***
  • Posts: 179
    • View Profile
Re: Purpose of this bracket??
« Reply #13 on: June 27, 2014, 08:51:40 PM »
Let's see what we come up with.

69Z28-RS        09C       NOR      Z28      Has Bracket
Hans L              ?         VN         ?         No Bracket
69 Z28             ?          ?           Z28     Has Bracket
Bryan302         05A       NOR      Z28      No Bracket
Logged
Bryan S.
1968 RS Z/28, 12E, PNT R2, TR 749
1969 Z/28 X33, 05A, PNT 52 52, TR 719, VE3

69Z28

  • Hero Member
  • *****
  • Posts: 928
  • 69 X33D80 Z28
    • View Profile
Re: Purpose of this bracket??
« Reply #14 on: June 27, 2014, 08:59:34 PM »
Quote from: Bryan302 on June 27, 2014, 08:51:40 PM
Let's see what we come up with.

69Z28-RS        09C       NOR      Z28      Has Bracket
Hans L              ?         VN         ?         No Bracket
69Z28             06A      NOR     Z28        Has Bracket
Bryan302         05A      NOR     Z28        No Bracket


Hi Bryan I added the missing data for mine.
Logged
GaryC

'UNRESTORED' 1969 Cortez Silver Z28 X33 D80
Pages: [1] 2  All
« previous next »
 

anything