Replace Powerglide with a 4 speed Muncie

[dellswo]

1967 Camaro 327 with a Powerglide. I am switching over to a Muncie 4 speed and I do not see a place to attach the clutch return spring. A big block has a metal bracket you attach to the exhaust manifold. Where do you attach the clutch spring to on a small block?? I have a rod that connects to the clutch fork and the other end of the rod connects to a spring. The spring has to hook on something but I cannot figure out what ... Help I don't want to drill a hole in the engine mount ... What did the spring attach to from the factory ??

[L6Ragtop]

There should be a small hole (for the spring) in the engine mounting bracket.

Dan

[dellswo]

Is the engine mounting bracket also called the motor mount ?? I checked that and there are no holes on either mount ( passenger or drivers side) . If I have to
I can drill a small hole into the mount for the spring ......

[JohnZ]

That's the engine mount frame bracket - look closely and you should see a small hole in the flange that overhangs the rear edge of the crossmember.

[dellswo]

Is this the engine bracket ? I do not see a hole on mine ?

[dellswo]

or isthis the bracket that should have the hole in it for the spring ??

[JohnZ]

The first photo (the frame bracket, not the rubber mount) should have the small hole for the clutch return spring.

[VXC961]

I know it's probably not at the top of your list, but if you get a chance could you take some pictures and/or describe how the process went?  I've got a '68 with a powerglide, and I've contemplated the same swap many times.

Thanks, and sorry I didn't have any advice to offer.

OCB

[deejaygee]

Here's a photo I found of a clutch return spring on a 67 small block (no, not mine).

[69CamaroConv]

I swapped a pg for muncie. I couldnt find any hole for the return spring so i made one lol