Where to look for build sheet on very original 67

[Rohebo]

1st post here.

I've read that build sheets in '67 Norwood cars is rare.  But if I was going to take the time to start pulling things apart on my car where would be the best place(s) to start?

It's a 327 convertible with original seats/covers, door panels and carpet.

Thanks in advance.

[lakeholme]

Look under the back seat. You'll pull it anyway.

[Rohebo]

I should have noted that I've already had the back seat out (top and bottom) as well as both rear side panels (detailing...).

[JohnZ]

Look under the back seat. You'll pull it anyway.

Not a good location - the rear seat (and rear carpet) was installed by Fisher Body, long before the Chevy broadcast sheet even existed.

[Mike S]

 I've heard the drivers side gas tank top was another area to look at.

Mike

[Rohebo]

Not sure if it matters much, but this is a very late build '67 (July - can't remember the week).

So it sounds like dropping the tank might be worth a shot.

I've blindly "felt" under the front seats and didn't feel anything.

Is there a chance it could be behind the front-seat back?

[JohnZ]

Not sure if it matters much, but this is a very late build '67 (July - can't remember the week).

So it sounds like dropping the tank might be worth a shot.

I've blindly "felt" under the front seats and didn't feel anything.

Is there a chance it could be behind the front-seat back?

You won't find one on the gas tank on a Norwood car, or in the front seat back (the front seats were installed by Fisher Body too).

[69Z28-RS]

John,

that leaves the question:
'Is there ANYWHERE on a Norwood car where there *might* be an accidentallly tucked build sheet??"

[Rohebo]

Exactly!  Perhaps I need to phrase this differently.

In what locations has anyone (or you know of someone else) found the build sheet on a Norwood built car?

I'm particularly interested in a '67, but at this point I'll take whatever I can get!

This isn't a big deal for my car as it's not a high-option car (and the RS shows on the trim tag).

And I have the protect-o-plate that lists the door edge guards code!

Thanks again in advance for any info.

[69Z28-RS]

Your protecto plate lists 'door edge guards'  that surprises me.... but I don't know much about '67 PTP...

[Rohebo]

Gary,

Those door edge guards are about all I got!

Here's a link to where the '67-'69 protecto codes reside on CRG (all the way near the bottom):

http://www.camaros.org/numbers.shtml

[JohnZ]

John,

that leaves the question:
'Is there ANYWHERE on a Norwood car where there *might* be an accidentallly tucked build sheet??"

No. The statistical probability of finding a broadcast sheet on a Norwood car is zero.

[69Z28-RS]

thanks John.      so there is no need to wish/hope.. or look. 

[sbmiano]

my 69 z28 built 04D Van Nuys.  When it was restored they found build sheet taped to gas tank

[rsr]

Are you saying no bodybroad cast sheets have been found in Norwood cars?