« previous next »
Pages: [1]

Author Topic: wheel opening moldings  (Read 3868 times)

clean68rs

  • Member
  • ***
  • Posts: 34
    • View Profile
wheel opening moldings
« on: January 04, 2013, 01:16:30 PM »
I have a 68rs and my question is, should the front wheel well molding be full length and the rear wheel well molding end at the side quarter panel molding? In the catalogue that is the way it is suggested. I just would like to know if this is the way thay came stock. Thank you Scott.
Logged

william

  • CRG Member
  • *****
  • Posts: 3193
    • View Profile
Re: wheel opening moldings
« Reply #1 on: January 05, 2013, 04:28:13 PM »
No.

As verified by many road test photos in vintage car magazines both '68 RS wheel opening moldings ended at the side body molding. The '68 RS is also the only 1st gen that did not use the rocker panel spears.
Logged
Learning more and more about less and less...

clean68rs

  • Member
  • ***
  • Posts: 34
    • View Profile
Re: wheel opening moldings
« Reply #2 on: January 06, 2013, 02:35:50 AM »
Thank you William for helping me out with that. Ive looked at so many different pictures and seen them done so many diffrent ways I didnt know what to think. Thanks again Scott.
Logged
Pages: [1]
« previous next »