69 Z questions

[jdv69z]

Am working on my 69 Z and have two questions:

1. I'm trying to remove the clutch fan/pulley from the water pump; Have removed the nuts from the studs, but the fan and pulley don't want to come off. I don't want to doing prying, etc. or I'll need a new water pump. Anyone have this problem and a solution?

2. I need to re-wrap some wiring in the engine bay. What is the tape that I need? Original looks like black friction tape? Wires are to starter so come close to engine block. Anything that resists heat that might be recommended?

Thanks,

Jimmy V.

[Pacecarjeff]

For your fan clutch - I always just use a big hammer.
Just give it one good wack - that will get it off.

[GaryL]

The wrap for the wiring harnesses was just a black plastic tape with no adhesive. Rick's sells it. #RC-508. If they sell it then most stores will have it.

[firstgenaddict]

There is a cloth type tape and I believe that is what you are referring to when you say "friction tape" I believe the cloth tape is more resistant to heat and wear...

[JohnZ]

The cloth-type tape will get deductions in judging, as the original harnesses were wrapped with non-adhesive shiny black plastic tape, as noted by Gary.

[jdv69z]

Thanks, I'm getting the tape from Rick's. No issues with judging; my car is a very nice driver and doesn't attend many shows; mostly country roads on nice weekend afternoons.

Jimmy V.