'68 Wiper motor issues

[feastersss]

I'm trying to install the crank arm on the back of the motor and I'm following the diagram in the assembly manual UPC 1 A2, if I hold my wiper motor following the picture, one alignment mark is opposite the picture, does anyone have a good picture of a '68 wiper motor (back view), I was told this was for a '68, can't find any #'s on it!

[Camarocards]

Here's my '68 wiper motor.

Bob

[feastersss]

Thanks!

[z28z11]

If you want to be absolutely certain of the crank arm in the park position, temporarily mount the motor on the firewall (so it grounds properly), hook up all wiring to the motor and cycle it at least one time (on and off with the switch). Remove the motor, mount the arm and you'll be all set. The timing marks are not absolute - they can denote a range that the arm should fall in between.

Regards,
Steve

[feastersss]

Thanks, that worked great, appriacate the help!

Scott