« previous next »
Pages: [1]

Author Topic: head gaskets  (Read 5583 times)

SH69Z28

  • Member
  • ***
  • Posts: 33
    • View Profile
head gaskets
« on: October 20, 2006, 06:13:07 PM »
In rebuilding my '69 DZ motor, I would like to know what the original head gasket thickness was. My Chevy dealer recommends an .041 inch compressed composition gasket but something makes me think the original ones were thinner.

Thanks.
Logged
69 Z/28 Fathom Green, mostly correct with chassis broadcast sheet
69 Z/28 Dusk Blue, incorrect drive train, my driver

firstgenaddict

  • Hero Member
  • *****
  • Posts: 2882
  • caretaker of 1971 LT1's 11130 & 21783
    • View Profile
    • Groome Family Automobiles
Re: head gaskets
« Reply #1 on: October 20, 2006, 08:08:30 PM »
Originals were steel shim head gaskets.
Not sure of the thickness but I am going to say somewhere around .015-.020
Logged
James
Collectin' Camaro's since "Only Rednecks drove them"
Current caretaker of 1971 LT1's - 11130 and 21783 Check out the Black 69 RS/Z28 45k mile Survivor and the Lemans Blue 69 Z 10D frame off...
https://plus.google.com/photos/112392262205377424364/albums?banner=pwa

JohnZ

  • CRG Member
  • *****
  • Posts: 4365
    • View Profile
Re: head gaskets
« Reply #2 on: October 21, 2006, 08:26:45 PM »
The original steel shim head gaskets were about .018"-.019", and shouldn't be used for a rebuild unless the deck and heads are freshly machined; otherwise, use composition gaskets, which are available in several thicknesses from .030"-.050" - they'll seal fine if corner-to-corner deck flatness is within .003", but steel shim gaskets won't.
Logged
'69 Z/28
Fathom Green
CRG
Pages: [1]
« previous next »
 

anything