Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - janobyte

Pages: [1] 2 3 ... 102
1
6-cylinder Camaros / Re: Been awhile
« on: February 09, 2023, 08:50:19 PM »
Very nice👍

2
Maintenance / Re: Winter storage
« on: August 13, 2022, 10:48:31 AM »
Search: under lift jack stands

Tripod, screw lift.

What supports my suspension,,and, safest way to work under the lift.

3
Restoration / Re: carpet
« on: July 07, 2022, 03:32:13 PM »
.

4
Restoration / Re: carpet
« on: July 07, 2022, 03:30:33 PM »
Scrutinizing eyes will note the autometer fuel gauge(the old SW never worked right, discovered wrong ohm, dealer screw up) and the 69 shifter boot,,I just like the look. The vintage Hurst us getting shelved.

Use your old carpet to get in the ball park for measurement.
 Can always trim off,,can't add. Cook inspires me to post,,lol!

5
Restoration / Re: carpet
« on: July 07, 2022, 03:06:47 PM »
👍on the ACC two piece.

Probably one of the easier tasks. Leave all the bolts in for reference. White marker and a solder iron. Heavy duty shop scissors and razor blades. Weights. there are some good write ups on the site. "Carpet installation"

6
Maintenance / Re: At a loss - engine stalls under load
« on: July 07, 2022, 02:57:44 PM »
Checking plugs to see if you have a rich or lean condition asap after the issue.

7
Maintenance / Re: At a loss - engine stalls under load
« on: July 06, 2022, 04:53:08 PM »
Just throwing it out there: have somebody ride behind you to see what, if any, color smoke out the exhaust. When it dies, don't try to start, pull and read the plugs,,lean vs. rich condition. Does it die or fall on it's face pulling a holeshot?

Normal operating temp?

8
General Discussion / Re: Timing
« on: June 05, 2022, 11:00:12 PM »
Read JohnsZ tech article on timing, this site.

My 302 has always liked 38 degrees, full advance.

Good fuel.

9
Restoration / Re: '68 wheel and tire size questions
« on: June 05, 2022, 01:08:46 PM »
Check out Team Camaro.
Probably a day worth of reading on this topic.👍

10
X2 on the black screws. X2 on the Satin finish.
My dash looks like yours Joe.

11
Agree with reply #5.
Mine is for certain smooth.
That being said, very little in the suede finish on the dash. Never even noticed until reading on this site. Then it was like oh yea,now I see it,,,trace. 04d Norwood car.

12
Originality / Re: Preservation of a 68 Camaro
« on: March 11, 2022, 06:19:50 PM »
Black face in mine..
Also didnt spot the fuel gauge top pic,,nice

13
Originality / Re: Preservation of a 68 Camaro
« on: March 11, 2022, 05:10:34 PM »
You probably already know, but you can utilize the two screws underdash (ash tray mount) for your gauge bracket. Very secure. I'll send you a pic how they mounted the tac in place of the fuel gauge,,,in 68. Very simple and I like it anyway. Lose the amp gauge, throw a 0-90 ohm fuel gauge in it's place. Just an opinion, the way I like it set up.

Green or black on you lol, I Iike the both.

14
Originality / Re: crayon marking on the lower fender extensions ?
« on: March 07, 2022, 07:09:25 PM »

Lol😂
Austin?   Are you wasting time on facebook?  :)

15
General Discussion / Re: My 69 Z28 NRCS Data Report
« on: February 14, 2022, 11:56:14 PM »
I'm sure plenty of others, but Harley was pushing 883's when I was stationed in Germany, mid 80's.

Pages: [1] 2 3 ... 102
anything