1
Restoration / Re: Subframe
« on: May 27, 2012, 01:52:19 PM »
Any idea on why the z-bar would be angled towards the front of the car on the engine?
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Restoration / Subframe
« on: May 26, 2012, 03:28:08 PM »
Does anyone know if the cross member and trans mount are offset on a 69 firebird subframe vs a 69 Camaro?
I have not been able to find information on the location of these, just the body mount and radiator mount locations.
I am currently in the process of restoring a 69 396 Camaro and the Engine seems to be to far forward.
The subframe is out of a 69 Firebird which i was told would work. All the mounting holes to mount the body / radiator were the same.
The motor mounts are in correctly with the taller mount on the drivers side.
The Z bar for the cluth is not straight and is angled towards the front of the car and the driveshaft is short about 1".
Help is greatly appreciated.
Thanks Rich
I have not been able to find information on the location of these, just the body mount and radiator mount locations.
I am currently in the process of restoring a 69 396 Camaro and the Engine seems to be to far forward.
The subframe is out of a 69 Firebird which i was told would work. All the mounting holes to mount the body / radiator were the same.
The motor mounts are in correctly with the taller mount on the drivers side.
The Z bar for the cluth is not straight and is angled towards the front of the car and the driveshaft is short about 1".
Help is greatly appreciated.
Thanks Rich
Pages: [1]