Messages

1

General Discussion / DZ 320 piston dome height ?

« on: May 02, 2016, 04:22:34 AM »

Somebody says me, what is the height of the piston dome DZ 302 original GM ??

Thank , Paul

2

Restoration / CROSS MEMBER POSITION

« on: May 24, 2013, 12:06:55 AM »

I Have a 68 camaro SB 4 speeds and is in several parts since a long time ago , i dont remember What is the position of the cross member ?

The transmission should she moved to the left side ( Driver ) of the oval hole like on this image , or cross member it must be reversed for the transmission shifted to the right side of the oval hole ?

I wait yours answer

Thank , Paul

3

General Discussion / 1969 ORIGINAL Z-28 CAMARO ''ENGINE FRAME MOUNTS'' WITH ""DZ'' 302

« on: February 02, 2012, 04:13:50 PM »

WE HAVE A IMPORTANT QUESTION !!

IT IS A NORMAL THAT THE ''ENGINE FRAME MOUNTS'' AT RIGHT ( PASSENGER SIDE ) IS MORE HIGHER THAT THE LEFT ( DRIVER SIDE ) ??

WE NOT SHURE IS THAT OUR ''ENGINE FRAME MOUNTS'' ARE CORRECTLY TO INSTALL FOR THIS MOMENT ??

BECAUSE , THAT DRIVES THE ENGINE TOWARDS THE LEFT ??

HOWEVER , OUR ''ENGINES FRAME MOUNTS'' HAVE 4 SMALL MARKS ON THE TOP , AND ACCORDING TO WHAT TO HAVE READ , ONLY THE ''ENGINE FRAME MOUNTS'' FOR Z-28 1969 HAS THESE SMALL MARKS ?? !1

AND MOREOVER , THAT OUR ''ENGINE FRAME MOUNTS'' OF LEFT HAS THE SMALL HOLE FOR THE ''CLUTCH RETURN SPRING'' !!

PLEASE , GIVE ME LET US CAN HAVE TO US AN ANSWER CLEAR CONCERNING THIS QUESTION, BECAUSE WE DO NOT UNDERSTAND WELL WHAT IS WRITTEN ON THE SITE OF ''C.R.G'' :-(( !!

AND  MOREOVER , ON THE IMAGE OF THE SITE IT SHOWS THE ''ENGINE FRAME MOUNTS'' OF THE BIG BLOCK WHICH THEM ARE HIGHER ON THE LEFT ( DRIVER SIDE ) WHAT MOVES ENGINE TOWARDS THE RIGHT , THUS OPPOSITE AS OF OUR ??

I WAIT YOUR ANSWER , THANK PAUL

PS ; SEE THE IMAGE OF OUR CAR FOR SEE THAT !

4

Restoration / find door glass of camaro 1968 with ''ASTRO VENTILATION'' to engrave like compan

« on: November 13, 2009, 08:30:12 AM »

I need brand new door glass of camaro 1968 both side with the logo ''ASTRO VENTILATION'' to engrave like company ?

is what that exists and or then I to find some ?

because , I do not have to find yet :-(

( sorry for my english )

I wait your answer

Thank , Paul