Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Emo1956

Pages: [1] 2 3 ... 11
1
General Discussion / Re: 68 Z28 Console alignment
« on: August 08, 2020, 03:50:00 PM »
 Hi, something else that could also effect the shifter and it may be a long shot if everything is where it's suppose to be and still hitting. Try measuring the sub-frame or check the bushings in the sub-frame. It wouldn't take much to make the shifetr hit on 1 side . Good luck . Emo

2
THank you ,thank you  everyone . As always you come through..   Emo

3
Had to replace the frame rails on the car so I need to put the plates back. The body shop through out the old rails and I forgot to tell them about them . Where can you buy them ?

4
1969, is it on both sides ?

5
Thank you very much .. Do you have any dimensions on it ?? 

6
Hi everyone . I am looking for some pics or where to go to find them. Looking for pics om the rear divers side frame rail that has a bracket of some kind on like BBC Canaros or Z-28 cars. As always much appreciated because you are the best .. Thank you Emo

7
OMG Facebook !!! I have to turn the computer off after reading some of statements they make there. I sell some parts there since Ebay started adding all the taxes but FB is a complete nightmare !!

8
I was just surprised because of the knowledge that so many here have in the CRG. There was actually a thread I found on these pushrods and the 0 stamped rockers together. Almost impossible to find some of this stuff today. Thank you for responding . Emo

9
Ok I did some digging and they are the blue tip pus rods for the 302 #3796243 Thanks everyone for looking

10
I can't believe  that nobody has said anything !

11
Hi everyone ;are these what I think they are ? I remember seeing a set a very long time ago but not sure if these are what I remember. Thank you Emo

12
General Discussion / Re: '69 DZ carb restored, on Facebook Marketplace
« on: January 27, 2020, 12:56:05 PM »
I spoke to Harold about the color and he said that the goldish color will turn to that green with the heat and time. The difference of color between the bowls and metering block is the heat. Fuel keeps the bowls kooler so they don't turn as dark.Most people don't know that dychromate wasn't to color them but to stop them from rusting .

13
General Discussion / Re: '69 DZ carb restored, on Facebook Marketplace
« on: January 17, 2020, 11:24:35 PM »
Hi everyone. Those are my carburetors and the reason there that color is I wanted them to try and look more like the original Holleys. I remember the old Holley being more of a olive green color not that bright gold color that guys put on them. Harold Demes does the carbs and from he has said you can longer get the original cadmium dichromate  to make that color. He has to do something different to get the color that I like.

14
General Discussion / Re: What is this fuel pump ?
« on: December 26, 2019, 04:57:16 PM »
more pics

15
General Discussion / Re: What is this fuel pump ?
« on: December 26, 2019, 04:56:30 PM »
More pics

Pages: [1] 2 3 ... 11
anything