CRG Discussion Forum
Camaro Research Group Discussion => Maintenance => Topic started by: Bigfish45 on May 28, 2019, 03:15:03 PM
-
I'm getting ready to replace the brake booster on my 69 Camaro. When I installed the booster the first time years ago, there was no engine or front clip on the car and those 4 nuts were still hard to get to. Do any of you have any special 'tricks" or advice on how to get these 4 nuts off and back on the new booster? I know it is going to be very difficult. Any advice would be appreciated.
-
Probably going to need an angle or half moon wrench. When you put it back on start all 4 nuts before you tighten any. That will give you some wiggle room to get them started.